- Adam Mused Motors all spinning the correct way? If not swap two of the connects on esc
- Juan Carlos CV I guess all the motors r not at the same speed, do i correct that flashing the ESC?
- Juan Carlos CV I try it, but it doesnt work for me, I'm still having the same problem.. :s (I calibrate my ESCs)
- Peter Rosario I was building a 250mm racer and I had problem after problem. Now I have a Phantom and got no problems
- Scott DiNunzio Make sure the motors are spinning in the correct direction and your props are on the correct motor spinning in the correct direction.July 20 at 9:27am · Like · 1
- Marco Sederquist make sure the blades are on right and that you have motor #1 2,3 4 in the right ports...it's different for some FC on which is motor 1 etc..
- Patrick Bridges If everything else is good it might be in that controller , you might try putting a cheap little KK 2 board on itJuly 20 at 1:34pm · Like · 1
- Clyde O'Briant First, calibrate the ESC's,
Check motor order on Flight controller, ensure it is correct, and with the correct rotor orientation CW or CCW...See More - David Bingham The fact that's the entire frame is rotating like that seems to point to a problem with motor direction.
- Juan Carlos CV yep the entire frame is rotating, I already calibrate the ESCs. I'll check once again all the motor directions thanks
- Juan Carlos CV I find somehing new. All ESCs r the same, and after calibrating them. One still rotates faster than the others. Thats the reason the frame rotates and turns over. Im going 2 flash all ESCs this afternoon.
- Manas Jyoti Baruah al the ESC in the drone should be use same or differnt number of ESC wil use means if i use ESC 30 for one motor in the drone thn the other motor ESC 20 should i use or for the al four motor i should have to use same ESC tge is ESC 30
- David Schmid I'll bet a nickle it's a prop or motor spinning the wrong way.
- Juan Carlos CV nope, all props and motors r in the correct way smile emoticon
- Adam Mused Take it all apart and start over! If it's none of the problems that everyone mentioned then just start all over!
- Clyde O'Briant I'd check your radio and receiver to see what's doing. Maybe the rudder channel is switched, your trims are over to one side, something.
- Sungsoo Yoon Did you check right direction flight controller? I mean "Pointing to the aircraft nose direction"
- Manas Jyoti Baruah what ESC did u use in the drone
- Manas Jyoti Baruah You have use the ESC 30 to all the motor of the drone
- Tan Fyzie May i ask if you have the fc orientation facing the right way? Had my first quad with similar to this problem as i switch the orientation of the fc. Only to realise that once you had change the orientation of the fc, you will have to input the value in respectively in openpilot.
No comments:
Post a Comment